Hi All, I am look for a bit help. I have 2013 Mondeo Titanium X with led rear brake light. My brake light are not coming on at all included the centre light. I have changed the fuse and the two switches under the pedal I have power at the switch and power at the BCM/Central fuse box. All other lights and the cruise control are working. Ford mondeo 2008 mk4. petrol or diesel, diesel as had one of these wining sound on mine was the diesel pump seal ford wanted to put a new one on but found it was a seal they don't stock, but got a replacement from a bearings and seals company tool the old one in with me very cheap fix. if it is the power steering it would be the pump easy to 3. responses. When lights switched on engine mis-fires runs rough. car runs fine but when headlights switched on car runs rough and will not pick up revs problem not too bad if only side lights only on. 2003 1.8 petrol manual. Posted: Mar 16, 2011. 1. response. Auto xenon headlights set to high mot failure. You would have to trace the wiring, or see if the Haynes manual had a diagram. The switch may not go directly to the light, the BCM (electronic module in the interior fuse box) is usually involved. Other equipment (park sensors, trailer box) get the reverse status from the BCM over the CAN bus. Sometimes there is also a relay in the circuit. Check the illumination of other switches, they use the same illumination source, from the light switch. Also double check fuses F46, F67 & F68, they all supply the cluster (IC). See what else works, like wipers, lights etc. They are controlled from a separate module, if most of them work, then at least battery power is getting to some of the car. Kevin0323 Discussion starter. 626 posts · Joined 2006. #4 · May 24, 2010 (Edited) Anything red or blue on the interior doesn't turn on. The radio still works and the LED still shows the stations etc. The clock still works. The overhead map lights still work, and the window lights. Just not the red and blue lights. They're a straight swap, even between Mk4.0 and Mk4.5 (which is the one you're looking at on eBay there). Mondeo Mk4 2008 (BA7) saloon 2.0 TDCi 130 PS (well, 152 PS with the Bluefin installed) Zetec Auto (TF-80/81SC) Speedo cluster type 1, firmware: 0246. Audio system: Alpine iLX-700 (aftermarket) I'm not sure if number 1 is possible but I've done 2 & 3 on my UK 2015 mk5. I added reverse camera, rear DRLs, brake light flashes with indicator, 5 fashes of indicator and 12v socket time delay to 1s. Pin 38 => POSITION LIGHT FRONT LEFT (dimmed) Pin 57 => DAYTIME RUNNING RH (full bright) Pin 41 => POSITION LIGHT FRONT RIGHT (dimmed) This should clearify if they are set correctly by the BCM. You could also unplug it and put 12V to those pins to see if the connection is ok. All signals for the DRLs are routed through a connector (C11-G/H) on 7r2BD.

mondeo mk4 dash lights not working